Optimization of magnetic properties in fast consolidated SrFe12O19 nanocrystallites

Publikation: Bidrag til tidsskrift/Konferencebidrag i tidsskrift /Bidrag til avisTidsskriftartikelForskningpeer review

DOI

The magnetic properties of SrFe12O19 nanocrystallites produced by hydrothermal synthesis and consolidated by Spark Plasma Sintering (SPS) were optimized by varying the compaction parameters: sintering time, sintering temperature, uniaxial pressure or pre-compaction in a magnetic field. Highly textured compacts with a high degree of crystallite alignment were produced. Qualitative and quantitative textural information was obtained based on X-ray diffraction pole figure measurements. The optimum sintering conditions, relating the degree of alignment and bulk magnetic properties, were identified based on the resulting magnetic properties. It was found that one must strike a balance between the degree of crystallite alignment for high saturation magnetisation and coercivity (Hc) to gain the highest energy product (BHmax). It was found that the coercive field drops when the crystallite alignment increases. This was particularly pronounced in the case of magnetically pre-aligned powders prior to SPS, where Hc and BHmax decreased as the pellets became increasingly textured. The best BHmax value of 29(4) kJ m−3 was found for the sample sintered at 950 °C for 2 minutes with an applied pressure of 100 MPa for a powder pre-aligned in an applied field of 0.55 T. The results presented here show the potential of SPS consolidation of SrFe12O19 with high relative densities and emphasize the effect of the degree of alignment on the decrease of coercive field and its influence on the magnetic performance.
OriginalsprogEngelsk
TidsskriftR S C Advances
Vol/bind9
Nummer23
Sider (fra-til)12968-12976
Antal sider9
ISSN2046-2069
DOI
StatusUdgivet - 26 apr. 2019

Se relationer på Aarhus Universitet Citationsformater

ID: 151521259