Aarhus Universitets segl

Impact of sulphate source on the hydration of ternary pastes of Portland cement, calcium aluminate cement and calcium sulphate

Publikation: Bidrag til tidsskrift/Konferencebidrag i tidsskrift /Bidrag til avisTidsskriftartikelForskningpeer review

  • Elsa Qoku, TU Bergakademie Freiberg
  • ,
  • Thomas A. Bier, TU Bergakademie Freiberg
  • ,
  • Gert Schmidt, TU Bergakademie Freiberg
  • ,
  • Jørgen Skibsted

The present work investigates the hydration and evolution of solid phase assemblage as a function of sulphate source in ternary Portland cement (PC), calcium aluminate cement (CAC) and calcium sulphate (CS¯HX) cement pastes. Two binders are compared, a PC‒rich and a CAC ‒ CS¯Hx ‒rich paste, containing gypsum and anhydrite as sulphate carrier, using a multi-method approach including calorimetry, XRD, TGA, MAS NMR spectroscopy, microscopy and thermodynamic modelling. The overall phase assemblage is very similar for the two-sulphate source in both PC-rich and CAC ‒ CS¯Hx−rich systems. However, the quantitative X-ray analysis, TGA and the 27Al, 29Si NMR show that the amounts of the crystalline hydrates and X-ray amorphous phases are influenced by the type of sulphate. In the long-term hydration, the anhydrite-bearing formulations exhibit the highest amount of ettringite, whereas the gypsum-containing samples develop a higher fraction of AFm phases and X-ray amorphous hydrates. This difference may relate to faster dissolution kinetics of gypsum compared to anhydrite in the studied ternary blends. For the CAC ‒ CS¯Hx −rich pastes, gehlenite from CAC (C2AS) shows hydraulic activity, which primarily results in the precipitation of strätlingite. Higher amounts of strätlingite are identified in the gypsum bearing samples, suggesting that the type of sulphate source impacts the hydration of silicate-bearing phases. Finally, the phase assemblages from thermodynamic modelling (using the GEMS software) are found to be in good agreement with those observed experimentally, although some differences occur as a result of kinetic effects.

OriginalsprogEngelsk
Artikelnummer104502
TidsskriftCement and Concrete Composites
Vol/bind131
Antal sider19
ISSN0958-9465
DOI
StatusUdgivet - aug. 2022

Bibliografisk note

Funding Information:
The authors wish to thank Mrs. C. Ludewig for preparation of the samples for SEM and TGA and for conduction of the TGA measurements. The use of the facilities at the Laboratory for Solid-State NMR of Inorganic Materials, Department of Chemistry, Aarhus University, Denmark, is greatly acknowledged.

Publisher Copyright:
© 2022 Elsevier Ltd

Se relationer på Aarhus Universitet Citationsformater

ID: 289998375